It would be no trouble to make one for the Kel-Tec. My email address is in my sig below.
April 16, 2008, 05:01 AM
This DeSantis Pop-Up Holster (http://www.desantisholster.com/020.html) looks great and doesn't cost a lot. I haven't used one but I've heard good things about it. Their Tuck-This holster is great but unfortunately it's not made for the P-3AT.
April 16, 2008, 04:29 PM
I just got my galco usa in today. it serves its purpose well, just don't expect to use a belt wider than 1" with it. that J hook is short
April 17, 2008, 05:48 PM
just happened to be cruising through KD Holsters website and found they carry the Mini-IWB Defender for the Kel Tec P3AT
April 19, 2008, 09:51 AM
The P3AT is best in a pocket IMHO. Heck, I carry my P11 almost 100 percent of the time in a pocket anymore. However, this happens to be the finest leather I've ever experienced, Mitch Rosen Workman, a tuckable. It's expensive and worth every dime of it. It's a comfortable rig and beautifully made.
Lots of good choices out there but stay far, far away from anything Crossbreed.
May 3, 2008, 02:46 AM
After taking this photo and photoshopping and saving it I realized you are looking for "tuckable" so this may not help. However since i did all that here it is anyway.
It it a Desantis. Cheap, thin but stays open for reholstering and rides anywhere IWB without feeling it. You can see however I trimmed it on the bottom and glued the stitching to prevent unraveling. Only did this because I felt it a bit too much in 1:00 position while sitting.
The funny shape is molded by me to accomadate a CT laser on the trigger. Otherwise it fits a p3AT great without the extra bump.