lead pellets for bullet casting


PDA






dodo bird
February 19, 2014, 04:56 PM
Anyone use fired airgun lead pellets for bullet casting?

If you enjoyed reading about "lead pellets for bullet casting" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Arkansas Paul
February 19, 2014, 05:05 PM
I would think they would be pretty close to pure.

If they are, they would be good for BP stuff.
If you're gonna use them for modern loads, you'd need to add something to them to harden them up a little.

That's assuming they're pure, which I think they are. They're pretty soft in any case.

Scooter22
February 19, 2014, 05:34 PM
They are mostly pure lead and soft as noted. You can blend them with other metals like tin and antimony to make up a harder alloy such as Lyman #2. Do a web search for alloy recepies. Only problem is most pellets are well under 20 grains so your gonna need alot to cast a batch of larger bullets. Wheel weights are the best cheap option if you can get them. Just use the dull gray ones. The shiny silver ones have zinc on them and zinc even in very small amounts will make a batch of alloy not fill out the bullets and cast properly. Get a copy on the Lyman Cast Bullet Handbook. It's the bible of bullet casting. Good luck.

dodo bird
February 19, 2014, 05:35 PM
I dont cast, however i have a good pellet trap that recovers my pellets pretty well. I have been keeping them. Better than throwing them in the trash.

Arkansas Paul
February 19, 2014, 05:45 PM
^ If you save up several pounds, I have no doubt you could sell them. Even a few dollars is better than throwing them out.

tiamat
March 28, 2014, 12:53 PM
Conversely, does anyone re-cast them for use as pellets again?

NuJudge
March 29, 2014, 07:20 AM
You can find discussions on both recovering Lead pellets for melting, and casting new pellets from Lead on the Yellow forum:
http://www.network54.com/Forum/79537/

Some pellets intended for high velocity are not Lead, now. I don't have anything to do with these, and have no experience with them, but if they are Zinc, they will cause no end of problems with Lead casting.

Many people on the Yellow forum are casting for large caliber air guns, up to caliber .50.

tiamat
March 29, 2014, 05:27 PM
.50 caliber air guns? that's pretty intense.

If you enjoyed reading about "lead pellets for bullet casting" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!