Rebarrelling the 91/30 Moisin Nagant


PDA






Clark
February 20, 2003, 03:41 PM
I had to improvise to get the extractor relief cut. My rotary table thru hole was too small for the 1.25" bull barrel. I rotated by hand and clamped in the mill vice with a work stop to locate.

If you enjoyed reading about "Rebarrelling the 91/30 Moisin Nagant" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Clark
February 20, 2003, 03:43 PM
The shape of the extractor is like a hook.

Steve F
February 20, 2003, 04:05 PM
Nice work there;)

Big_R
February 21, 2003, 04:27 AM
Clark:

What caliber are you rebarreling for or are you sticking with the 7.62 X 54R?

Ryan

P.S. Nice work.

Badger Arms
February 21, 2003, 01:13 PM
http://www.thehighroad.org/attachment.php?s=&postid=126137http://www.thehighroad.org/attachment.php?s=&postid=126141

Clark
February 21, 2003, 02:19 PM
It is a wildcat that is a 45/70 that shoots the cheaper lighter 45acp bullets.

That is a .452" 16" twist Shilen steel barrel blank.

The case is a 45/70 that the top 1" is run through a Lee 45acp carbide die.

I had to open up the bolt face, and when I shoot it at the range Monday, it will be single shot.

Clark
February 21, 2003, 02:20 PM
http://www.thehighroad.org/attachment.php?s=&postid=127760

Clark
April 30, 2005, 12:10 AM
OK, I stayed up until midnight, and did it right this time.
That is the Russian's 1945 cut on the bottom and my April 29 2005 cut on top.

If you enjoyed reading about "Rebarrelling the 91/30 Moisin Nagant" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!