Threading an AR-15 Noodle Barrel


PDA






Badger Arms
September 13, 2004, 03:18 PM
I have a DPMS light contour barrel on my post-post and would like to get the barrel cut to 14.5" and a flash suppressor permanently installed. Can a lightweight barrel of this size be threaded successfully? Who can do the permanent welding portion of the job?

If you enjoyed reading about "Threading an AR-15 Noodle Barrel" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Dave Markowitz
September 13, 2004, 04:38 PM
Is it lighter than A1 contour? If it's the same as an A1 barrel I don't see why not.

ADCO Firearms seems to have a good rep for this sort of job.

If you enjoyed reading about "Threading an AR-15 Noodle Barrel" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!