[TooTech]

If you've got a Bushnell Elite 4200 6x24 scope would you PLEASE measure the objective portion of the scope from the front end back to where it has narrowed down to meet the 1" scope body?

I'm trying to figure out if this scope will clear the back sight blade on my CZ527 Lux rifle. This is a long scope and I'm hoping the scope is long enough to reach OVER the rear sight blade before the objective bell starts to flare out.

Thanks!

[Swamp Yankee]

OK, if I understand your request here's some dimensions I measured from my scope.
Front of scope to 1" transition= 5.750 inches
Front of scope to front of turret block=9.315 inches
Need anything else just holler.
Take care

[TooTech]

Thanks Swamp Yankee! That's the number I was looking for!