Benelli front sight post


PDA






Slimjim
May 25, 2005, 09:22 PM
Does anyone know what size the nut is on the front site post on the benelli m1 super 90. Mine is slightly off and i cant seem to find one small enough to fit it in my box, but i may need a whole new set of micro wrenches, is it metric or standard, does anyone know what size i need or someway to get it loose to reposisiton and tighten it?

If you enjoyed reading about "Benelli front sight post" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
DougW
May 27, 2005, 08:56 PM
Had the same problem. Couldn't get the info, so I called a friend that has a M1 Super 90. He used needle nose plyers. I figured, what the hell, and did the same thing. I guess you could take the barrel to a hardware store and see if someone can help you fit an open end wrench to it. I boight the smallest crescent wrench I could find, and it was too big to fit in the slot. Good luck.

Slimjim
May 27, 2005, 11:09 PM
Its a 15/64th inch wrench. You need a set of ignition wrenches to get the right one.

If you enjoyed reading about "Benelli front sight post" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!