[megatronrules]

I have one of these that I'am going to do-dad so to speak i'am going to order a pistol grip buttstock for it as well as heat shield and a shot shell holder. I was wondering if anyone makes an extended magazine tube or mag tube extention for it? Also how do I get the stock buttstock off this gun? I've tried bolt buster and a screwdriver but nothing it won't budge. I have a drill thats reversable what if I get a flat head screwdriver bit for it? This won't strip the bolt will it? Thanks for any help guys

[Badger Arms]

Nope. The design prevents installation of an extension.

[dfariswheel]

Don't use the drill, it's more likely to damage the bolt head, not strip the threads.

To remove, get a large screwdriver blade bit for a interchangeable
bit screwdriver.
Put the bit into a socket wrench and use this to break the bolt free. The bit goes into a small socket, and the socket is attached to the extension bar, and is then put into the socket handle.

You can also use a screwdriver that's set up to use a "cheater" handle, or a screwdriver with a shaft that can be gripped with a Crescent wrench.

Any one of these methods will give you the leverage to break the bolt free.

[TechBrute]

No on the extension, but you can get a brand new one with the long mag for about $200.:D

To remove the stock, I'm assuming you've already removed the recoil pad. Get a ratchet with an extension and the right sized socket. I think it's a 1/2 inch, but I can't really remember. Use that to remove the bolt. Trying to use a long screwdriver will only result in goofing up the head of the bolt and a lot of frustration.