Tangent Hi-Power Sights

[che4rev]

How does one remove the tangent sight from an Inglis Hi-Power?
Does it require bending the ears on the slide?

[George Stringer]

I don't think anything that drastic is required. I don't know right off hand how to remove it and I can't find anything on it. But you might try http://www.fnhipower.com/ if nobody posts an answer here. George

[guy sajer]

It can be a pain in the butt .

There is a very strong leaf spring underneath it . You have to apply quite a lot of pressure at the front of the sight leaf . Lots ! At the same time , after you detect that the sight was pushed down , pull rearward on the whole sight .

Good luck .

Almost forgot , why does it need to come off ?

[che4rev]

I want to refinish it. Thanks for the advice on how to get it off. I would have never thought of that in a hundered years.

[Jim Keenan]

FWIW, that is the same way Mauser rifle and pistol (C96) sight leaves are removed. Note that the K.98k rifle, and a few others, have a cross pin that has to be driven out first.

Jim