.355 bullets in a 38sp?


PDA






trickyasafox
January 11, 2006, 03:57 AM
i have a considerable amount of 115gr and 124gr jhp .355 bullets. can the 124gr .355 be safely loaded with light 125gr 38sp data or is it like knocking on the devils door?

If you enjoyed reading about ".355 bullets in a 38sp?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
ReloaderFred
January 11, 2006, 04:03 AM
You can load them with any .38 Special data for that weight bullet. They may not be as accurate as .357" or .358" diameter bullets, depending on your barrel. Some of the older Colt Pythons were bored at .356", and were considered to be more accurate because of it.

Depending on your expander plug, too, the bullets may be loose in the neck of the case, but not necessarily so. Many people routinely load 9mm bullets in .38 cases because they want to use that particular bullet weight. You don't have to worry about using light load data with a smaller diameter bullet, but if the case were reversed, such as using .357" diameter bullets in a 9mm (.355") bore, then you would have to work up your loads accordingly.

Hope this helps.

Fred

bakert
January 11, 2006, 04:24 AM
I've used the 9MM 125 gr lead bullets at times when short of the 158 grs I normally use in .38 Sp. Just had to adjust the load accordingly. If your resizer reduces the case enough for a fairly good bullet pull I would think you could load and taper crimp them and they would work OK. Like ReloaderFred said the accuracy might not be quite as good but you might be surprised at the results especially if you shoot at 8 to 10 yds at an indoor range like most of my shooting or even as a plinking load in the field.

Starter52
January 11, 2006, 12:00 PM
I loaded up 500 lead RN .355 bullets in .38 Spl. cases after finding that my 9mm didn't like lead bullets. I took the expanding plug from the 9mm die set and used it in place of the .38 plug. The bullets loaded and shot just fine with 3.0 gr. WW 231.

trickyasafox
January 11, 2006, 01:46 PM
im actually shooting them out of a 79' colt python, that i think has the tighter bore, though i've never slugged it.

ReloaderFred
January 11, 2006, 02:28 PM
Then you shouldn't have any problems shooting them in the Python. They may also shoot fairly well. You won't know until you give it a try.

Fred

If you enjoyed reading about ".355 bullets in a 38sp?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!