HELP! STUCK ROUND


PDA






david_the_greek
January 15, 2006, 01:24 AM
I was poping some spent primers out of the casing on my pistol reloader and a shell got stuck in the actual pin set up that hangs down. Its a rotating reloader with a big slot machine type pull and after unloading some rounds I noticed that one still had a primer sticking halfway out. being smart I held it up under the pin and lifter the crank arm. BAD IDEA. The casing is stuck (but primerless:) ) and I cant wrench it out so I am not sure how or if I have to take this whole contraption apart. sorry for being vague but i'm writing this before I go for a run. I'll try to post manufacturer etc when I get back. THANKS FOR ANY HELP

If you enjoyed reading about "HELP! STUCK ROUND" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Chawbaccer
January 15, 2006, 10:50 AM
Get your decapping stem out of the way, drill and tap the primer hole for a quarter inch bolt, use a socket and washers that allows the case to come clear of the die, thread quarter inch bolt thru the socket and into the die and keep tightening untill the case pulls free.

Or go to your local gunshop and they probably will do it for free.

david_the_greek
January 15, 2006, 03:39 PM
haha well I like the second but being as I got myself stuck I'll try to get it out myself. Or I'll try to the point where it will not be broke and if I can't do it I'll have to fess up and destroy head over to a gun shop. pride/reloader in hand

If you enjoyed reading about "HELP! STUCK ROUND" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!