Gordon
April 18, 2006, 09:13 PM
A couple members requested pictures of my Paras. They have shot about 5k rounds between the 2 of them. The P-14 has all USGI Sear,disconnector,sear spring,hammer strut,firing pin stop, plunger and guide, thumb safety and the grip safety which I welded a hump(no body makes them for spur hammers?) and finished. The firing pin and extractor are Wilson Bullet proof and all the springs are Wolff.It has a duty 4.5 pound crisp series 80 pull!:) It shoots Federal American Eagle in 2" at 25 yard off a rest! It went 1000 rounds in the AZ dust with out cleaning! I used MD X-7 lube. I am gonna keep shooting it another K or until I get a Malf!I might put a Wilson Bullet proof slide stop and a GI link in and get the
sights changed to Tritium replacements.
The P-13 is a carry/back up to the P-14. It is only 3" accurate same conditions as the P-14. It has a Wilson Bullet Proof extractor and firing pin. All springs are Wolff. It had a nice 4 pound trigger from the factory AND the sights were well regulated! This gun has never malfed in 5 years of use/carry.
These are my using/go to battle guns. I LIKE single stacks however and these Paras are butt ugly so here is an extra pic of something Good to LOOK:D at!
sights changed to Tritium replacements.
The P-13 is a carry/back up to the P-14. It is only 3" accurate same conditions as the P-14. It has a Wilson Bullet Proof extractor and firing pin. All springs are Wolff. It had a nice 4 pound trigger from the factory AND the sights were well regulated! This gun has never malfed in 5 years of use/carry.
These are my using/go to battle guns. I LIKE single stacks however and these Paras are butt ugly so here is an extra pic of something Good to LOOK:D at!