remington 760 takedown


PDA






America_without_liberals
May 1, 2006, 10:11 AM
Can anyone tell me how to take apart a remington 760? In particular I need to know how to take off the foregrip that is on the pump slide. Gun needs reblued.

If you enjoyed reading about "remington 760 takedown" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
dfariswheel
May 1, 2006, 03:19 PM
First, here's an exploded view of the 760 showing the parts:
http://www.again.net/~steve/page7a.htm

Here's disassembly instructions from The NRA Firearms Assembly 3:

1. Push out the receiver pins and remove the trigger plate assembly by sliding it forward and down.

2. Remove the magazine, press the action bar lock and open the action about half way.
With the bottom of the rifle UP on the bench, insert a snug fitting punch or steel rod through the holes in the action tube.
Unscrew the tube by turning the tube with the punch counterclockwise until it can be removed.

3. Close the action and remove the barrel, bolt and bolt carrier from the receiver.

4. Holding the bolt carrier, pull the barrel forward until the bolt releases from the barrel extension.

5. Push the bolt carrier with the bolt, free of the action bar.

6. Tilt the front of the fore arm downward and slide the barrel out between the action bars.

Once disassembled, the wood forearm is held on the action bar assembly just like a Remington 870 shotgun.
There's a round nut (Part #29) inside the front of the forearm that must be unscrewed to allow the wood to be slid forward and off the action bars.
This requires a special spanner wrench, which can be made from a section of steel pipe, or a piece of 1/8" thick steel plate.
WARNING: DO NOT try to unscrew the nut with pliers or poorly fitting tools, the thin action bar tube can be damaged if you slip.
Buy or make a good tool for this.

To reassemble, reverse.
When reassembling the barrel into the fore end assembly, don't spread the action bars more than necessary to get the barrel bracket (Part #23) into place.

To reassemble the barrel and bolt assemblies into the receiver, be sure the indent in the curved end of the ejection port cover (Part #34) is locked ahead of the lug on the bolt carrier. The cover must enter the small slot in the top of the receiver freely. DON'T force it.

qajaq59
May 2, 2006, 06:19 AM
You can also get an owner's manual from Remington. I just sent for one so I am not sure how much info is in it yet, but it can't hurt to have one. http://www.remingtonsociety.com/

America_without_liberals
May 2, 2006, 01:37 PM
Thanks to both of you. The only problem that I am having is getting the slide tube to free up. This rifle has gunk everywhere. Someone also sprayed it with black paint at some point. I started removing that last night and found that they sprayed right over top of rust. Some people's kids just shouldn't be messing with these things.

If you enjoyed reading about "remington 760 takedown" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!