[Jmurman]

Here is my list for starting out reloading.

Please tell me if I am missing anything, ok? I am reloading for my M1 Garand and a Rem 700 30.06

RCBS Rockchucker Starter Kit
RCBS Die-Full length
RCBS X-Dies
RCBS Swager kit
Redding Powder Trickler
RCBS Shell plate#3
RCBS Primer pocket cleaner
RCBS Bullet puller and and collett
RCBS Case trimmer
Carttidge Sizing guage

Lyman Turbo Twin Tumbler
Media
RCBS media separator

MTM ammo boxes

I have a digital caliper and an electronic scale. Other than bullets, powder and primers...am I missing anything?

[The Bushmaster]

A powder scale. Ya need a powder scale or dippers...:) Oh. wait a minute. The kit has one doesn't it...Jumped the gun there a bit...Enjoy...

Manual? Got Manual? Or two....

[Jmurman]

I have the Lyman manual and I get a Speer with the RCBS kit.

[Bullet]

Looks good.

[Jim Gross]

Not to side track the thread but I am looking at starting to reload myself and was just wondering about how much the initial cost would be to get going with this setup. thanks

[Jmurman]

"Not to side track the thread but I am looking at starting to reload myself and was just wondering about how much the initial cost would be to get going with this setup. thanks"

I ordered this stuff from 3 sources. Midsouth, Midway and Cabelas. I added 500 168gr Sierra MK's and 100 165gr SPBT Sierra GameKings and a couple of ammo boxes from Cabelas and it came to approx $600.

I ordered the RCBS press and dies from Midsouth, but their site is really confusing, so that all I got from them. Midway has the best site and I really like their feedback and comments portion of the site. That really helped me make an informed decision, especially on the tumblers and media.