Problem cocking Erma EP22


PDA






Autoloader
July 14, 2006, 02:35 AM
This Erma is a .22 Luger look alike. The problem is that when the toggle is pulled, the firing pin block(hammer) impacts on the sear and stops.The sear release is preventing the sear from dropping to allow the hammer and bolt to go back and cock. If you pull the trigger, of course then it will cock. But once it releases the hammer it's locked up again. I have a parts illustration and have taken it down several times and all of the parts are in it that should be except the safety lever and ring. I took that out because the lever was damaged and I have another one ordered.
Thanks for any help.
http://cot.net/~davidc/Pictures/EP221small.jpg.http://cot.net/~davidc/Pictures/EP222small.jpg.http://cot.net/~davidc/Pictures/EP223small.jpg.http://cot.net/~davidc/Pictures/EP224small.jpg

If you enjoyed reading about "Problem cocking Erma EP22" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
If you enjoyed reading about "Problem cocking Erma EP22" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!