Bad hammer or not? Spec question...


PDA






JeffC
July 17, 2006, 10:49 PM
Kuhnhausen notes that the hammer pin holes should be .1575" +.0020" and for comparison the hammer pin should spec .157" - .002"

So the hammer I have in question mikes .161 on one side and between .162" & .1625" on the other... For comparison this one's hammer pin measures .155"

I voiced this concern with the manufacturer, and asked for a new hammer & sear as one corner of the sear looked prematurely worn since only one hammer hook was bearing on the sear. When the pistol was returned to me it had a new sear but they did not replace the hammer.


Opinions?

If you enjoyed reading about "Bad hammer or not? Spec question..." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Jim K
July 18, 2006, 06:56 PM
That sounds like a pretty sloppy hammer pin fit, so I am not too surprised that there are other problems. FWIW, a hammer bearing on only one side of the sear is fairly common on factory guns; they will sometimes wear in.

Actually, this seldom is even noticed, so just out of curiosity, how did you find this problem, or do you mike every part of a gun to see if it is in spec?

Jim

JeffC
July 18, 2006, 07:23 PM
I first noticed the hammer was a leaner, then noticed I could press it upright a few degrees, then I miked it and noticed both holes were larger than spec, and one moreso and egged... I put the factory parts in the spare parts bin and after needing to send the pistol back for a few other things I stuck the factory ignition pieces back on. I expected they would replace the hammer but they only replaced the sear.

The trigger pull did suck out of the box, another reason I took the factory parts off in the first place.

And I am a mikeaholic, Jim :evil:

Clipper
July 18, 2006, 08:32 PM
...When a dowel pin hole would get opened too far and you weren't about to spend a lot of time with the fix. Lay the hammer on a sturdy flat surface, and set a ball bearing 2-3 times the diameter of the hole in the oversize hole, and strike sharply with a hammer. The rim of the hole will extrude in and down slightly. Now, either redrill, or preferably ream the hole.

JeffC
July 18, 2006, 08:44 PM
...When a dowel pin hole would get opened too far and you weren't about to spend a lot of time with the fix. Lay the hammer on a sturdy flat surface, and set a ball bearing 2-3 times the diameter of the hole in the oversize hole, and strike sharply with a hammer. The rim of the hole will extrude in and down slightly. Now, either redrill, or preferably ream the hole.


Hey, that's an idea... but my luck I'd crush the hammer :scrutiny:

If you enjoyed reading about "Bad hammer or not? Spec question..." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!