Bulldog Cylinder latch


PDA






Edward429451
May 5, 2003, 10:04 AM
My CA Bulldog, non-Pug (2.5" bull bbl) suddenly won't release the cylinder by actuating the release latch on the frame. I can pull the extractor rod and it releases fine but using the latch alone wont push it far enough forward to release the cylinder.

This is a one owner gun. I haven't run anything through it hotter than 13 gr of 2400 behind a 245 Keith. In fact, it dont get shot much at all, around 100 rnds a year.

I tried to figure it out without any disassembly and came up empty. It works fine, no binding or excessive looseness (for a bulldog) but it bugs me. Any ideas?

If you enjoyed reading about "Bulldog Cylinder latch" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
If you enjoyed reading about "Bulldog Cylinder latch" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!