Fitting a new #4 mk2 ejector


PDA






Fatelvis
May 5, 2003, 03:44 PM
My old one doesnt kick out the spent brass, it just stays in the receiver. I replaced the exractor spring (with a new one), but it didnt help. Is the ejector just worn down too short? Is it as simple as just ordering a new one and replacing the old one, or does it have to be fitted? If so, is it difficult? Thanx a million!

If you enjoyed reading about "Fitting a new #4 mk2 ejector" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
4 eyed six shooter
May 5, 2003, 09:31 PM
Just get a new ejector screw and install it. It should not require fitting.

If you enjoyed reading about "Fitting a new #4 mk2 ejector" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!