Millet adj rear sight blade loose


PDA






CraCZ
August 15, 2006, 05:44 PM
Does anyone know what the cure would be to keep the rear blade from easily moving from side to side after the left/right screw has been tighten? Is their suppose to be a spring inside there or something? If so there is not one in there when you take the set screw out. Maybe I just need to get a new rear sight or maybe just locktight it. Thanks for any help.

If you enjoyed reading about "Millet adj rear sight blade loose" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Sunray
August 16, 2006, 02:03 AM
"...get a new rear sight..." What's it on?
"...easily moving..." That under recoil or finger? Are you sure it's the rear sight that's moving? I'm wondering if the front sight is on properly. Assuming you changed that too.

JoeHatley
August 16, 2006, 12:08 PM
I've got Millet rear sights on 3 of my revolvers. A Ruger, Dan Wesson, and S&W, and none of them have any looseness. Sounds like you may have lost a detent or your spring has been crushed.

I'd contact www.millettsights.com and see if they can help you out.

Good Luck...

Joe

CraCZ
August 16, 2006, 06:10 PM
Thanks for your help Joe and their web site.

If you enjoyed reading about "Millet adj rear sight blade loose" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!