Kahr polymer frame question/problem.


PDA






glennv
August 16, 2006, 06:14 PM
I just bought a CW9 and test fired it today. I had zero malfuntions shooting 400 rounds. When I went to clean it I noticed the right front frame rail was about half as thin as the other rails. It looks as though it was cut away on the underside of the rail. The picture is poor but all you need to see is the location. Is this normal.

http://i7.photobucket.com/albums/y260/kramervalentine/PICT2150.jpg

If you enjoyed reading about "Kahr polymer frame question/problem." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
warmrain
August 17, 2006, 01:41 PM
The plastic frame rails are not a functional or structural part of the gun, they are just there to assist in getting the slide back onto the frame. I don't think this is an issue.

mdao
August 17, 2006, 02:49 PM
It's normal. My CW9 looked like that.

glennv
August 17, 2006, 03:35 PM
I plan to run another 3-400 rounds through it before I start carrying it, but so far the gun isa sweet shooter.

If you enjoyed reading about "Kahr polymer frame question/problem." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!