National Match question


PDA






1 LT MPC
September 1, 2006, 10:55 AM
Anyone remember what recoil spring (and hammer spring) poundage is factory set for th NM. When my dad passed away, he left me his NM Gold Cup and two recoil springs (along with firing pin or hammer springs). I know he shot a lot of 185 gr semiwads and would change the springs for 230 ball. One spring is listed at 20 pounds but I think that is not the factory issue.
The Colt is a .45 with the NM serial prefix.:confused:

If you enjoyed reading about "National Match question" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Canuck-IL
September 1, 2006, 12:19 PM
14 and 18#s usually works - not sure if that was factory issue however.
/Bryan

Jim Watson
September 1, 2006, 12:48 PM
Standard recoil spring for G.M. is 16-17 lb; "heavy duty" is 18. Obviously a 20 lb worked for your Dad, but some people say that too much recoil spring slamming the gun shut can be as bad as too light a spring letting it slam open.

Target load springs are obviously lighter, I use a 12 lb spring in the gun I shoot with light load semiwadcutters; it was not 100% with a 14 lb.

I read once that the Colt assembler just clipped a standard spring until the Gold Cup functioned with 185 gr mid-range semiwadcutters.

If you enjoyed reading about "National Match question" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!