TODDctu
October 15, 2006, 08:49 PM
Can someone help me with the removal of a Remington model 31's trigger group?
I have removed the large pin toward the rear of the receiver that allowed me to pivot down the trigger group a few degrees. I have been advised that the smaller pin that is only on the left side of the receiver is a pivot pin. The trigger group will slide in the receiver grooves a little both directions. Which way should it be pushed to clear this pivot pin if that is what it is?:confused:
870 Armorer
Mod 700 Armorer
Mod 31 plumber
I have removed the large pin toward the rear of the receiver that allowed me to pivot down the trigger group a few degrees. I have been advised that the smaller pin that is only on the left side of the receiver is a pivot pin. The trigger group will slide in the receiver grooves a little both directions. Which way should it be pushed to clear this pivot pin if that is what it is?:confused:
870 Armorer
Mod 700 Armorer
Mod 31 plumber