[Lupara]

:confused:

Maybe I'm a little dumb (PC: technically challenged), but the combo of RCBS Uniflow + Powder Measure Stand + Micro Adjustment Screw gives me problems:

I have reactivated my Uniflow by fitting a Micro Adjustment Screw to it. Together with a baffle (made out of a beercan) it throws very vonsistent charges, but whenever I operate the handle of the Uniflow, the Micro knocks against the Powder Measure Stand, not allowing the Measuring Cylinder to fill completely with powder. This cannot have been the inventor's idea.

How do you operate this combo? Any suggestions for improvement? THX

[Peter M. Eick]

How are you getting the micro screw to hit the mount stand? I cannot think of how this is occuring. Can you post a picture?

[brickeyee]

Put a die lock nut on the powder measure above the stand.