Help installing a BM Base pin!


PDA






Waffen
November 3, 2006, 12:22 AM
Gentlemen,


I reacently received a Belt Mountain base pin and I'm having a bit of trouble installing it on a Ruger New Model Blackhawk. It seems that the pin fits the cylinder snug as a bug, however it just will not clear the first frame hole (the one with the base pin latch). It goes in about 1/2mm and thats it.

I know I probably need to lap the holes in the frame, but how do most of you go about doing this? What material should I use and what tools will I need to do this?

Any help is greatly appreciated. It's obvious this belt mountain base pin is superior to the factory one and I want to use it bad!

If you enjoyed reading about "Help installing a BM Base pin!" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
bakert
November 4, 2006, 09:31 PM
See if this link helps you.
http://www.realguns.com/archives/008.htm

If you enjoyed reading about "Help installing a BM Base pin!" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!