Very close but the one I had marked was different.
I've decided now to go a whole different route, if it works out I'll post pics, if it doesn't I'll never tell. :)
Thanks for the link!
November 21, 2006, 01:23 PM
I hope it works out for you. :)
November 21, 2006, 07:39 PM
Went a whole different route to the problem. The door pockets were like $50 for five guns, additional "pockets" extra, of course.
Went to Home Depot, spent $4 on a piece of 1"x6" pine and began cutting, screwing and gluing.
Didn't turn out bad if I do say so myself. :rolleyes:
November 22, 2006, 12:24 PM
I use a pot lid holder, ( heavy duty, plastic coated wire) from Lowes, about $10.00, holds 9 guns and works great.
November 22, 2006, 03:57 PM
tegemu, Can you post a picture of the pot lid holder
November 23, 2006, 06:40 AM
Looks pretty good, but if I were you I'd stain and then clear lacquer the shelf, as most lumber these day's has been treated, and the chemicals could potentialy damage the finish on your firearms.
November 23, 2006, 09:33 AM
I'd stain and then clear lacquer the shelf
I finished it with a coat of sealer and three coats of enamel spray paint.
November 23, 2006, 10:59 AM
I'm sorry but pictures, me and computers are a deadly combination. You can see the rack at any Lowes or Home Depot in the kitchenware dept. It is made of wire, like a dish drainer, Heavy duty plastic coated wire. it is about 1 foot long, 6 inches deep and 5 inches high at the ends. There are 9 vertical separators between the ends, which are about 2-3 high and angled with the apex of the angle up. The rack easily holds 9 guns. They might show it on their websites.
If you enjoyed reading about "Handgun safe door pockets??" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!