Need help w/ my Yugo M-48!


PDA






pinetree64
May 26, 2003, 04:05 PM
In my desire to rid her of cosmo, I noticed the follower looked like at came off rather easy so I removed it. It was packed with cosmo. Well it is a couple days latter and I'm reassembling her. I was real careful to label all the screws etc, the follower looked easy. The follower was a PIA to get back on, and now that I have it on, I'm not sure if is correct.

There are 3 tabs, two at the front and one the rear, unless I have it backwards. I slide the thin piece of the spring up under the front two tabs and then forced it under the one in the back. Now I'm thinking maybe the back tab rests on top of the spring and does not retain it. I appreciate the help. It just doesn't look right...

Thanks,
tjg

If you enjoyed reading about "Need help w/ my Yugo M-48!" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Jack19
May 27, 2003, 09:51 AM
Parallax (http://pub113.ezboard.com/bparallaxscurioandrelicfirearmsforums)

Ask there. They know everything there is to know about milsurps.

dfariswheel
May 27, 2003, 01:43 PM
The rear lug retains the spring, so you have it assembled properly.

If you enjoyed reading about "Need help w/ my Yugo M-48!" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!