Ruger .44 Magnum carbine maintainence


PDA






khofmann
December 22, 2006, 12:01 PM
A question for youse guys.

I was trying to dissassemble the bolt and slide of my carbine per the ruger instruction manual but ran into a part discription problem/ Paraphrased as follows:
",remove the trigger guard-reciever pin", and" This "pin" is not referenced in the parts list and I do not want to make a mistake and loose something.:uhoh: Does anyone know what the component part number (C-?)is is for this pin, as referenced in the Ruger Carbine component parts list?:banghead:

Any help is always appreciated

If you enjoyed reading about "Ruger .44 Magnum carbine maintainence" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
DnPRK
December 22, 2006, 12:32 PM
Part C-5 joins the trigger guard to the rear of the receiver.

khofmann
December 22, 2006, 07:34 PM
makes sense now that you id'd it. Thanks again

If you enjoyed reading about "Ruger .44 Magnum carbine maintainence" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!