[arinvolvo]

Ok, one thing wrong with this picture of a SIG 228.

No hints.

http://www.thehighroad.org/attachment.php?s=&postid=302897

[arinvolvo]

MODS...could you please move this to Autoloaders general discussion? I accidentally pisplaced it.

[caz223]

The pin just over the trigger is 'shopped out.

[Mal H]

You've messed up the model markings (photoshop?). But that's probably not 'it'. caz223 may have hit it, the screw over the trigger appears to be missing.

Wrong trigger? (Shouldn't it be a lighter tone?)

[ebenw]

on the controls, screws, hammer, and trigger... (these "accents" could me new to their newer models, though)

And I agree with the earlier post... missing screw above the trigger.

[cadfael]

I had to run up to the safe to look at my 226, but its defintely the screw over the trigger.

Adam

[arinvolvo]

Damn Caz....I thought this one would take a little longer than that...

ok, you win:rolleyes: :p

And by the way...looking at your own SIG is SO totally cheating:neener:

[caz223]

I don't have that particular model sig, but I do have one of their catalogs. ;)
On the front cover of their 2002-2003 price list is a close-up of the area just over the trigger guard of that model, or a very, very similar one.

That catalog, among many others usually resides right next to my computer, so I didn't have to go very far.

[arinvolvo]

Cmon though...tell me what a good photoshop job I did...I was pretty impressed with it.:D

[GitSome45]

What about the "rollpin" holding the breech block inside the slide...?

I see a "Hole", but no rollpin.

Howard

[arinvolvo]

The rollpin is black, makes it look like just a hole.