[357mag357]

Does any one know what size bolts I need to mount the press? Also, what is the correct Lee powder dispenser for this press? Is it the Lee Pro Auto Disk or the Lee Auto-Disk Powder Measure? Thank you.:confused:

[Rod B]

I used 5/16" carriage bolts to mount my Classic turret press to the bench.

Go with the auto disk pro, it's a much better measure than the std model.

BTW. Don't forget to order the riser for the measure. This is a must for use with the Safety prime system.

Rod.:)

[strat81]

Rod B. is 100% correct. However, I used lag bolts in place of carriage bolts. Same difference.

[DaveInFloweryBranchGA]

+2 what Rod said. Go with the 5/16" and Pro Auto Disk.

Dave

[Vitamin G]

I got 2 pieces of nice wood-like countertop from Home Depot, and mounted them together to make one really thick piece, and then used one screw\bolt, and two wood screws with the little plastic thing that expands when the screw is screwed into it, making it extremely secure.
The good thing is I never have to remove my press from the wood, which I C-clamped onto my desk. Its a little higher, plus portable.