Removing DPMS Flash Hider


PDA






Drakejake
February 22, 2007, 04:07 PM
I bought my DPMS Panther Lite less than a year ago. It has a flash hider with surfaces for a wrench. I am told that these are merely screwed on and that the threads on the barrel are one-half by twenty-eight. So there is no solder or pin? The FH can be unscrewed with sufficient muscle power? One unscrews this counterclockwise as you are looking at the muzzle?

Thanks,

Drakejake

If you enjoyed reading about "Removing DPMS Flash Hider" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Bartholomew Roberts
February 22, 2007, 04:48 PM
Assuming that you have a 16" barrel, the flash hider should just be screwed on and can be unscrewed with the appropriate wrench and a little muscle.

Make sure you don't have a 14.5" barrel with permanently attached muzzle device to bring it out to 16" though.

If you enjoyed reading about "Removing DPMS Flash Hider" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!