Cleaning a blued gun?


PDA






valnar
June 10, 2003, 04:15 PM
I have all stainless revolvers except one... I just bought a new-to-me S&W model 19 blued .357.

What is the best way to clean this thing of lead in the cylinder without removing any blueing? Did I miss a FAQ on that?

Thanks,
Robert

If you enjoyed reading about "Cleaning a blued gun?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
stans
June 10, 2003, 08:15 PM
Lewis lead remover works well in the barrel as well as the chambers. To get lead off the frame or the exterior of the cylinder, plain old solvent and elbow grease. Lead Away cloths do contain a mild abrasive and will remove blueing.

valnar
June 10, 2003, 08:59 PM
Any experience with FP-10 that I've read about?

Robert

Standing Wolf
June 10, 2003, 10:23 PM
I always remove the cylinder and let it soak in a jar of Hoppe's No. 9 while cleaning the barrel and frame. As needed, I use a bronze-bristled brush inside the window and especially around the forcing cone. I always go over the entire frame with a used tooth brush and plenty of solvent. By the time all that's clean, the crud in and around the cylinder is usually loose. I would never use a stainless brush on a blued gun; for cleaning cylinder bores, however, I've found it helps to move up one caliber, which is to say: I use a .40 caliber bronze-bristled brush to clean the cylinder bores of a .38 special or .357 magnum. Again, I use a bronze-bristled brush on the face of the cylinder and extractor, and a used tooth brush everywhere else.

Cleaning up a used, neglected revolver is usually easier after it's been stripped to the frame and left to soak in mineral spirits a day or so.

I never shoot .38 special loads in .357 magnum revolvers: too messy to clean afterward. I load very light .38 special loads in .357 magnum cases to make cleaning cylinder bores easier.

If you enjoyed reading about "Cleaning a blued gun?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!