WECSOG replacement for a 5/32 carbide reamer (JP trigger installation)

PDA






atek3
April 12, 2007, 08:49 PM
So I bought a JP fire control system for my AR-15 and the JP oversized trigger pins. Installation looks straightforward, however the oversized pins won't go into the trigger without binding. The instruction manual says to use a 5/32 carbide reamer... I don't have a machine shop. What would be the WECSOG improvised equivalent.

thanks,
atek3
If you enjoyed reading about "WECSOG replacement for a 5/32 carbide reamer (JP trigger installation)" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
mrmeval
April 13, 2007, 12:36 AM
That was very nice of them to require that but not provide it. They run from 16 on up

http://cgi.ebay.com/New-USA-Solid-Carbide-Reamer-Straight-Flute-5-32_W0QQitemZ320002695869QQcmdZViewItem

It's meant to be used in a drill or mill. It is not exactly a 5/32 drill bit as it makes the hole very smooth.
If you enjoyed reading about "WECSOG replacement for a 5/32 carbide reamer (JP trigger installation)" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!