[KC]

Hi all

It was suggested in a thread in another forum that one could, if so inclined, replace the slide (or possibly just the barrel) of a Glock 21, and thereby swith calibers to .40 or 10mm. Since I can't seem to own too many different calibers (and refuse to buy yet another permanent handgun permit from the PRCa after the last one expired), this is appealing to me.

Am I delusional (which wouldn't be all that surprising) or is someone else blowing out their posterier. (I'd post the original, but now I can't find the darn thing...)

KC

[9x19]

There are conversion barrels that allow you to shoot .40 out of your 10mm Glocks, and allow .357Sig to interchange with .40s.

I'm not sure if the extractor/breechface dimensions on the Glock 21/30 allows for reliable use of the smaller rimmed 10mm/40.

You might take a look at www.lonewolfdist.com and see what they offer.

Good luck.

[Rich357]

You can buy a complete Glock 20 upper for you Glock 21. Take a look at www.glockmeister.com

I'm pretty sure the extractor and the rest of the lower assembly is the same.

Good luck,
Rich