holster for 4" pencil bbl s&w


PDA






gunhappy
May 16, 2007, 03:58 PM
If any one can direct me to a holster that will be good for ccw....preferably OWB(hi ride) or IWB.
Thanks ya'll.

If you enjoyed reading about "holster for 4" pencil bbl s&w" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Steve C
May 17, 2007, 01:25 AM
Two good places would be El Paso Saddlery/ (http://www.epsaddlery.com/) or Galco (http://www.usgalco.com/). Both places make excellent holsters in many different styles for revolvers.

Sistema1927
May 17, 2007, 09:24 AM
Recognize that most holsters for the heavy barrel will work just fine for your tapered barrel revolver. This is due to the fact that the front sight has to be the same height relative to the receiver for both models.

gunhappy
May 17, 2007, 02:50 PM
I had tried a Bianchi Shadow II for the 4" K-frame, and the barrel poked out. Maybe it was labelled wrong, but I measured from the frame to the tip of the barrel and it measured 4".

Sistema1927
May 17, 2007, 04:27 PM
Measured from where the barrel screwed into the frame? If so, then you are too short. Revolver barrel length is measured from the end of the barrel to the front of the cylinder. Possibly you have a 5" barrel.

gunhappy
May 17, 2007, 05:52 PM
if it's a 5", doesn't that increase the value?
Also, I found an online distributor for Ross Leather Holsters. Are these guys any good?

1 LT MPC
May 17, 2007, 08:15 PM
Value is increased only by a collector who needs a five inch.

If you enjoyed reading about "holster for 4" pencil bbl s&w" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!