Mauser Extractor Fitting?


PDA






jonnyc
August 9, 2007, 08:22 PM
I put a new extractor on my Israeli K98. Works great without rounds. Picks up and extract rounds great. Chambering and locking is hard on about half the rounds tried.
I am assuming I need to reduce the claw a bit but that the front foot, near the bolt head is fine.
Does that sound correct, and is there a special way to do this job?

If you enjoyed reading about "Mauser Extractor Fitting?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
jonnyc
August 10, 2007, 11:52 AM
No words of wisdom???

GunTech
August 10, 2007, 12:35 PM
Is this a military extractor? Does it have the bevel on the front? Are you feeding rounds from the magazine, or directly dropped into the chamber?

jonnyc
August 10, 2007, 02:22 PM
New extractor, probably mil-surp.
Yes, front is beveled.
From the mag.

If you enjoyed reading about "Mauser Extractor Fitting?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!