[Ky Larry]

I just bought a CZ PCR. The trigger is a little rougher than my other CZ's. Can anyone recomend a smith who works on CZ's?
Thanks

P.S. I haven't shot it yet so the trigger may shoot in. Any one have any experience with this?

[12 Volt Man]

Should get better with time. You could throw a snap cap in and dry fire the heck out of it. If you feel it needs a smith, you could call CZ-USA, they have a great smith. You also might call around locally and see if anyone has CZ experience.

[PCRCCW]

Recommendation #1.....Clean the snot out of it.
"" #2.............................Get good grease....aka Miltec.........
"" #3.............................Cover the trigger bar, sear, hammer etc..all trigger parts............
"" #4.............................Dry fire the snot out of it......until you finger bleeds.
"beat it until it bleeds and then beat it for bleeding".......:rolleyes:
"" #5.............................clean it very well again....and repeat. Your trigger will IMPROVE MUCH.............................mine feels like its had a trigger job and really, mostly....er, kinda .....hasnt.
Shoot well