mossberg 590a1 barrel on 590?


PDA






normv
September 28, 2007, 06:21 PM
Will the thicker/heavier barrel of the mossberg 590a1 work in a standard mossberg 590?

If you enjoyed reading about "mossberg 590a1 barrel on 590?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Smitty in CT
September 28, 2007, 11:04 PM
Yes, completely interchangable, it will even work on a 12GA model 500...

Atticus_1354
September 28, 2007, 11:13 PM
Why do you want the heavier barrel? Will you be shooting it so much it will make a difference? 50 rounds of buckshot through my regular 500 barrel didn't cause any problems.

Hoppy590
September 28, 2007, 11:13 PM
Yes, completely interchangable, it will even work on a 12GA model 500...


yes to the 590
No to the 500.
regular old 500's have a differant means of mounting the barrel and use a screw that screws into the magazine tube where as the 590 uses a nut to hold the 590 barrel to the magazine tube. as well as 500's having 6 shot tubes and 590's having 8 shot tubes.

L-2
September 29, 2007, 01:00 PM
regular old 500's have a differant means of mounting the barrel and use a screw that screws into the magazine tube where as the 590 uses a nut to hold the 590 barrel to the magazine tube. as well as 500's having 6 shot tubes and 590's having 8 shot tubes.

Partially correct. There are 18.5" AND 20" 590A1 models. There is also at least one 500 (that breacher model 54125) which also has the "clean out" mag tube. I suspect an 18.5" 590A1 barrel will fit on that 500 model, too (pictured below).
http://www.galleryofguns.com/prod_images/54125-MOS.jpg
Mossberg makes it hard on the logic it uses to assign model numbers.

Hoppy590
September 29, 2007, 06:51 PM
by definition, 590's only come in 20 inch the 9 in 590 denotes 9 rounds and 9 rounds can only be achieved in the 20 inch setup

mossberg does not list any 6 shot ( 18.5 inch barreled) 590s nor do i remember them doing so. i suspect any outside source selling 18 inch "590s" is just using the name loosly.


could be wrong.

Hoppy590
September 29, 2007, 06:54 PM
oh also. a 590a1 is a 20inch shotgun i do not know of any 18 inch A1's never mind any 18 inch 590s

MAKster
September 29, 2007, 11:49 PM
Mossberg does make the 590A1 with an 18.5" barrel and 6 shot capacity. They just don't include them on their website. See models 51411 and 51517.

Hoppy590
September 30, 2007, 02:44 AM
im un able to find a Mossberg referance on these model numbers. just a handful of hits on google to a few shops or listings.

regardless if im right or wrong (probibly wrong) but thats retarded model designations

MAKster
September 30, 2007, 12:20 PM
Here is a link to Mossberg's Law Enforcement models I found in an old thread.
http://arizonagunrunners.net/Products/Mossbergshotguns/mossbergshotguns1/mossbergshotguns1.html

normv
September 30, 2007, 10:08 PM
I have personally seen a shorter 590a1 (it was stamped on side of receiver) at a gun shop. 18.5" barrel and 6 shot capacity sounds right.

Going back to the original question, the thicker 590a1 barrel can be used in the standard 590 that comes with the thinner barrel, correct?

If you enjoyed reading about "mossberg 590a1 barrel on 590?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!