cpirtle
October 15, 2007, 02:54 PM
I've been sitting on my 1000 free Hornady 230 grain XTP's for about a year and figured it's finally time to load them up. (45 ACP)
I'd like them to be near the top of the power factor (after adequate buildup/testing of course).
The problem is I'm trying to find a specific loading for this bullet and I don't have access to a Hornady manual. I have Speer & Lyman and the local shops are out.
From my reading it would seem that Universal is a good fit and will get the bullet up around 900fps which is where I'd like to be (or a bit higher). They will be primarily shot from my 4" XD but may also be run through the USPc and 1911.
Anyone care to share a load they use? (COL would be greatly appreciated)
I also have plenty of Bullseye and Clays at home but picked up a pound of Universal today so I'd like to use it.
I'd like them to be near the top of the power factor (after adequate buildup/testing of course).
The problem is I'm trying to find a specific loading for this bullet and I don't have access to a Hornady manual. I have Speer & Lyman and the local shops are out.
From my reading it would seem that Universal is a good fit and will get the bullet up around 900fps which is where I'd like to be (or a bit higher). They will be primarily shot from my 4" XD but may also be run through the USPc and 1911.
Anyone care to share a load they use? (COL would be greatly appreciated)
I also have plenty of Bullseye and Clays at home but picked up a pound of Universal today so I'd like to use it.