Reseting zero on Leupold target turrest


PDA






Tosi
November 1, 2007, 12:43 PM
I have a leupold VX-II tactical with the 1/4 moa target turrets (not the m1 or m3) and I was wondering how I reset the knobs to zero? I know its the set screws but what should I use to undo them, its not very apparent by looking, a small allen wrench???? Thanks mike

If you enjoyed reading about "Reseting zero on Leupold target turrest" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
hksw
November 1, 2007, 12:53 PM
A very small Allen-type wrench should have been included with the scope if bought new or converted through Leupold (to add target turrets). The turrets should have three set screws nearly equally spaced around the circumference set in the grooved portion of the turret. loosening at least two should allow you to turn the turret's graduated cylinder but not the adjustments themselves. Once the zero is set, carefully tighten the screws that were loosened.

Tosi
November 1, 2007, 06:14 PM
Thanks, I got the scope without a box for some reason so I didnt have the hex wrench, but......... I went to put the sling on and got what i thought was a small screw driver from a rc car tool kit only to find out that it was mini hex head which I course tried on the turrets and found it to be the PERFECT size.

If you enjoyed reading about "Reseting zero on Leupold target turrest" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!