Bearing Question


PDA






LubeckTech
November 16, 2007, 11:19 AM
Does anyone know the I.D. and O.D. dimensions for S&W K frame end shake bearings? I've got my yoke anc cylinder prepped and may have a local source of the bearings. I don't mind getting them from Midway it's just the shipping cost that bugs me.

If you enjoyed reading about "Bearing Question" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Jim K
November 16, 2007, 03:23 PM
The OD is less than the ID of the cylinder and the ID is the same as the ID of the crane arbor. Anyone selling those shims should have them right; if not, are you sure you are getting the right thing or something someone ginned up?

Also you really have to square up the arbor with a special tool before installing the shim(s).

Jim

If you enjoyed reading about "Bearing Question" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!