Replacing grips on Beretta 92, use washers?


PDA






McKnife
November 30, 2007, 08:58 PM
Question... I just replaced the standard grips on my Beretta 92 with Hogue wrap-around grips and I was wondering if I need to use the 'grip washer' with these new grips.

I tried using the washers at first, but I found it unusually difficult to put the grip screws back in. I took them out and replaced the screws without the washers, and it works fine.

Am I supposed to use the washers?

Let me know. Thanks to all.

If you enjoyed reading about "Replacing grips on Beretta 92, use washers?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Tang
December 1, 2007, 12:24 AM
As long as the magazine will drop free you should be okay, if not the washers have to go back in.

10-Ring
December 1, 2007, 12:40 AM
On the few I've installed for friends, I did not use the washers

Onmilo
December 1, 2007, 11:40 AM
You shouldn't need the grip screw washers.
Just make sure you don't overtorque the screws and strip the frame bushings.

If you enjoyed reading about "Replacing grips on Beretta 92, use washers?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!