neck reaming


PDA






uk roe hunter
December 21, 2007, 01:41 PM
Guys,
I am pressing 308 win brass down to 7mm08. should i ream the necks and what is the best way to do it? is there a special method anyone knows?

Thanks

steve

If you enjoyed reading about "neck reaming" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Walkalong
December 21, 2007, 02:54 PM
You may not need to ream or neck turn them at all. It depends on the chamber in your rifle and how thick a loaded round is after seating a bullet in a resized case. If there is .003 or .004 difference, you will be OK. Check a number of them as they will not all be exactly the same. If it is bigger you will need to neck turn or ream your brass. Reaming is easier and just as effective for getting it down to a safe size.

Neck turning will not automatically give any better accuracy either. There are many variables. Neck turning is viable when shooting a tight necked chamber so you can "fit" your loaded rounds neck size to it to get a nice straight start for the bullet.

Here is a link to a Wilson Trimmer (http://www.sinclairintl.com/cgi-bin/category.cgi?category=RECTACWI&type=store) and reamers (scroll down) to fit it. They are top notch.

uk roe hunter
December 22, 2007, 05:03 AM
thanks mate.

If you enjoyed reading about "neck reaming" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!