[Rustynuts]

Not sure I'm reading the powder measure right. There are numbers by each hole, but when you slip the disk in, the number by hole being used is upside down. Are you really supposed to read the number that sticks out the far left? Instructions weren't too clear in famous Lee fashion! No video on Youtube for this either!

[Grandpa Shooter]

http://i249.photobucket.com/albums/gg233/grandpashooter/LeePowderMeasure.jpg

If this is the measure you are talking about, the disk is ready to install with the number .57 directly in line with the actuating arm. Just pick it up and slide it to where it drops down over the arm. Hope this helps.

[Rustynuts]

Yes, that's mine. I pretty much thought the number should be associated with the hole next to it, but since as it sets on the press, the number 57 would be upside down, I wasn't sure.