Got myself a Chinese now


PDA






res45
January 20, 2008, 10:44 AM
Ok got her today bluing was a little rough on the dust cover but the guy does bluing so he is going to reblue it for me free of charge,it took me good part of the day to get all the cosmo out of it, I still need to take the stock off again and work a little more out of it on the inside.

I stripped her down to single parts and cleaned everything,got It back together and a final wipe down before I took it out in the back yard put three rds. in the mag. I had and old brake cleaner can set up at about 30 Yds. I put the rear sight on battle position and busted the can dead center three out of three times I was a bit surprised to find it that dead on with no adjusting. As far as I can tell the rifle has never been shot till today.

Its a Factory /26\ 10 million serial with a capital A after the number,also has a triangle with a #8 inside it on the stock all matching number on everything. Rear sight has and inverted U on it,the spike bayo has 3 flutes, trigger groups is milled not stamped and barrel is threaded not pinned has the barrel nut and you can plainly see the alignment mark on the sides of the barrel and receiver.
http://i76.photobucket.com/albums/j1/rhsikes/Ammo001.jpg

If you enjoyed reading about "Got myself a Chinese now" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
If you enjoyed reading about "Got myself a Chinese now" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!