beretta 9000s


PDA






beretta9
August 3, 2003, 01:05 AM
Has anyone here have this problem with a 9000s in 9mm? Mine has over an inch of travel before the firing pin falls. By that time the trigger is so far back my finger slides off the bottom of the trigger and rubs on the trigger guard which has a very rough finish and rubs the skin off after a few rounds. I sent it back to the factory and they said is was within tolerances. They must have some very loose tolerances. I am kicking myself for not getting a glock at the same price.

If you enjoyed reading about "beretta 9000s" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
Mastrogiacomo
August 3, 2003, 09:55 AM
Are you registered on the Beretta forum? Try them out at www.berettaforum.net

Maybe they can give you better insight into your gun. I personally don't have this one myself: two Berettas type M and a future Glock 19 -- but the folks that have the 9000S should give good feedback.

beretta9
August 4, 2003, 06:20 PM
Thanks Mastrogiacomo, I will give it a try.

If you enjoyed reading about "beretta 9000s" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!