flip up sights, BUIS...


PDA






Dgreno
March 13, 2008, 12:44 AM
I have found myself wanting to switch from the standard front sight on my AR to a flip up type that mounts on a picatinny rail gas block. How hard is it to switch out the front sight to a railed gas block? Also, can anyone recommend a good BUIS for front and rear? Pictures would definitely be helpful!

If you enjoyed reading about "flip up sights, BUIS..." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
trinydex
March 13, 2008, 01:15 AM
http://www.ar15.com/forums/topic.html?b=3&f=18&t=206233

Bobarino
March 13, 2008, 03:19 AM
i have the Troy ind. rear sight, pic gas block and Bushmaster BMAS front sight

its easy. i put the DPMS 4 Picatinny rail on mine. i like the fact that i can fold the front sight down out of the way of the optic.

unload and make safe.

take the upper off the lower and remove the BCG/CH

remove the flash suppressor/muzzle brake and washer.

lighty lube the barrel to avoid scratching it when you slide the FSB off and your whatever on (i used the DPMS four rail gas block)

pop out the tiny roll pin that holds the gas tube into the FSB.

lighlty tap out the taper pins with a hammer and punch. sometimes it may take more than "light" taps. just be careful you don't scratch everything to heck.

slide the FSB off and your new gizmo on.

re-install the roll pin for the gas tube and align the gas holes. but Bobby, i can't see 'em! i know, grab a piece of 1/4" or 3/16" clear vinyl tubing, slip it over the gas tube in the receiver and blow while rotating/moving the new gas block around. where you get the least resistance is when the holes are aligned. leave it there and tighten the set screws.

re-install the washer and flash suppressor/muzzle break. install your front sight, go to the range and sight it in.

if you max out your rear sight adjustment, then your gas block is canted. loosen the set screws and rotate it in the appropriate direction and re-zero.

it seems more intimidating than it is. the hardest part about it is getting the top of the gas block level with the flat top.

http://www.thehighroad.org/attachment.php?attachmentid=34568&d=1138261729

http://www.thehighroad.org/attachment.php?attachmentid=34567&d=1138261632

Bobby

madcratebuilder
March 13, 2008, 09:52 AM
I have a YHM flip up front sight/gas block. Gas blocks are not hard to swap out, you do need to remove the flash suppressor. That can be a pita. My rear buis is a Matech, usgi issue.
http://i32.photobucket.com/albums/d37/madcratebuilder/PICT0016Medium.jpg

TIMC
March 13, 2008, 11:15 AM
I went with GG&G on my Beowulf.
http://img.photobucket.com/albums/v369/timc/Beowulfonbushlower.jpg

If you enjoyed reading about "flip up sights, BUIS..." here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!