Best press for using a collet die


PDA






BammaYankee
March 20, 2008, 11:00 AM
Hello all!
I'm considering an upgrade to my reloading press (currently have the Lee single stage O press to reload .308 match) only because I don't seem to be able to get a consistent even pressure on the neck sizing die the way the press is set up. Otherwise the press has served me well for many years.

Can anyone tell me which press they would suggest? I can spend about $150.

Thanks!

If you enjoyed reading about "Best press for using a collet die" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
30Cal
March 20, 2008, 12:31 PM
Sounds like a brass issue (does it have an accuracy impact?), not a press problem.

mpmarty
March 20, 2008, 01:01 PM
If the die is adjusted properly, the brass is all trimmed to proper length and the necks are reamed to uniform thickness you can keep your old press and life will be good.:)

Vern Humphrey
March 20, 2008, 01:33 PM
I use an ancient Lyamn Spar-T turret press with Lee Collet dies and it works perfectly. I also sometimes use a Lee Hand Press.

BammaYankee
March 20, 2008, 04:06 PM
Thanks for the replies!

I'll go back and reset the die and see if it helps. What got the gears churning originally was that when I tried to hand seat a bullet, for some cases the necks were tight, but for others it slid down into the neck. After running the latter back through and leaning on the handle a bit more, they tightened up. I just assumed it was the press... maybe I need to go to the gym more often! :D

YodaVader
March 20, 2008, 04:13 PM
Sounds like your press will do the job. I have a Lee Classic Cast Press (about $70 when I picked it up) that I use for all my rifle reloading including resizing with the Collet die. Has produced some of the best and most consistent accuracy for my .223 loads.

dagger dog
March 20, 2008, 08:10 PM
I have the cheapie Lee cast aluminum pot metal press and use the Lee collet dies in .223REM. and .308 WIN. in it as opposed to my RCBS Rockchucker. That I use for full lenght and seating with micrometer style dies.
You got the right idea about leaning on it harder!
I actually run mine through the collet 3 times rotating the case about 1/3 of a turn each time.

SASS#23149
March 20, 2008, 08:19 PM
Although your press should be able to get the job done,there just is no comparison between that press and a Rock chucker.The wight and mass of the 'chucker is just something to behold.I have the Lee,and my neighbor just bought a 'chucker.
They run right at 150.00 around here,from our local BiMart chain.

If you enjoyed reading about "Best press for using a collet die" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!