Help w/ failure to extract


PDA






conw
April 12, 2008, 12:05 PM
Yesterday I was shooting my P11 and it stopped extracting completely. Can't get it to extract snap-caps manually when I rack the slide they just sit in the extractor and go back in the chamber. I am afraid to use live rounds now.

Any suggestions would be really helpful. Thanks a lot.

If you enjoyed reading about "Help w/ failure to extract" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
rcmodel
April 12, 2008, 12:13 PM
P11 as in Kel-Tec P-11?

If so, your ejector is broken.

(It is extracting if it pulls the case out of the chamber, holds it, and puts it back in.)

Part #115 in the drawing.
http://www.kel-tec-cnc.com/p11parts.html

Call them and they will send you one free.
1-800-515-9983 and ask for service dept.

rcmodel

conw
April 12, 2008, 07:28 PM
Thanks for the tip. I took it by a local gun shop and the 'smith said it was snapped clean off.

rcmodel or anyone, know how hard it will be to install myself? I am ok at putting stuff back together, if it isn't "advanced" I should have it covered.

Kinda makes me mad though. But at least I don't have to send the gun off for weeks.

JDGray
April 12, 2008, 07:34 PM
I replaced mine, without taking it compleatly apart. It was pretty basic. Call KT, they will send you a replacement, or two:D

rcmodel
April 13, 2008, 03:39 PM
rcmodel or anyone, know how hard it will be to install myself?
Here ya go:
http://www.1bad69.com/keltec/disassembly.htm

rcmodel

If you enjoyed reading about "Help w/ failure to extract" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!