Lee perfect powder measure and the Powder charging die with Lee Reloader press?

PDA






JeepGeek
May 21, 2008, 05:18 AM
Got the die assembled to the measure, but am unsure how to mouht the ballchain to the press.

Anyone got this setup?
If you enjoyed reading about "Lee perfect powder measure and the Powder charging die with Lee Reloader press?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
bullseye308
May 21, 2008, 09:35 AM
The Reloader press is a single stage press not meant for charging powder on it. What most do is use whatever scale, weigh the charge out then set the brass in a loading block and charge it there. Then put the bullet seating die in the press and set the bullets.
jfh
May 21, 2008, 09:52 AM
The chain on the Perfect Powder Measure (and on the Pro/Auto Disk Measure) is the manual return feature provided for use on later-current model Pro 1000 and all Load-Master Presses.

Rather than mounting it on your Reloader Press, I'd suggest installing it on the bench near it, set up to facilitate a batch-processing workflow.

Jim H.
ForneyRider
May 22, 2008, 04:41 PM
You can mount the PPM on the Pro 1000?
If you enjoyed reading about "Lee perfect powder measure and the Powder charging die with Lee Reloader press?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!