I have a handgun scope mounted on my Dan Wesson with rimfire rings on the vent rib, using electrical tape as a buffer. But I want to mount it right. Brownell's or Midway have anything? Anyone else?
If you enjoyed reading about "Scope base for Dan Wesson model 15?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
June 27, 2008, 09:59 AM
B Square use to make a mount that clamped to the vent rib (barrel shroud) on Dan Wessons. It has been out of prouduction for a couple of years, but they occasionaly come up for sale on the Dan Wesson Forum and E bay.
The only other way your going to do it right is to have the top strap or rib drilled and tapped for a base.
June 27, 2008, 10:19 AM
I agree with rklessdriver. Here is a mount from Jack Weigand but requires drilling and tapping. I have also been told that B-Square is producing the Dan Wesson mount again. The mounts on B-Square's site are pricy though.
You might want to visit the Dan Wesson Forum (http://www.danwessonforum.com)for more info as well.
June 27, 2008, 12:54 PM
This is not a quicky bolt-on solution, but one I preferred to what was available commercially. Bought an extra barrel shroud, had the rib milled down to accept Warne quick release rings and bases. The bases are no higher than the original rib, so scope can be removed quickly for use of open sights.