Anyone know who sells wood grips for Rossi Revolvers?


PDA






volfandan
July 24, 2008, 12:42 AM
I'm looking at the Rossi 462 .357 2"....but I can't seem to find a source for wooden grips. Anyone know if they exist?

If you enjoyed reading about "Anyone know who sells wood grips for Rossi Revolvers?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!
dogngun
July 24, 2008, 08:28 AM
As far as I know, nobody.
Contact Eagle Grips and they might make a set for you.

mark

weregunner
July 24, 2008, 10:00 AM
Possible sources for wood grips for the Rossi.
www.wolfdensports.com
www.robertsontradingpost.com
www.gun-parts.com
www.ajaxgrips.com
www.grips4guns.com
www.gunaccessories.com

www.e-gunparts.com and www.brownells.com may have them,too

http://www.taurusarmed.net/forums/index.php?topic=6644.0
http://www.taurusarmed.net/forums/index.php?topic=1738.0
http://www.taurusarmed.net/forums/index.php?topic=1779.0
http://www.taurusarmed.net/forums/index.php?topic=6292.0

volfandan
July 24, 2008, 03:19 PM
Thanks fellas! This is a great start!

MCgunner
July 25, 2008, 09:07 PM
www.ajaxgrips.tom

bannockburn
July 25, 2008, 11:06 PM
volfandan

Let us know if you find any. Years ago I had a nice Rossi Model 88 revolver and couldn't find any decent aftermarket grips for it. Finally I added aTyler T-Grip adapter to it just to get the grip feeling a little better in my hand.

Elvishead
July 26, 2008, 03:37 AM
After some extensive research, I found some, or more over what fit's on the Rossi 461/462 for a good price.

If you send me a dollar, I'll tell you were to get wood grips and for a good deal too, and if you send me $2, I'll tell you another useful secret on how to improve your gun, if you promise not to make it public knowledge.

Flatfender
July 26, 2008, 03:48 PM
Gunbroker or eBay

mountaindrew
July 28, 2008, 02:12 PM
With some dremel work, I manged to fit a pair of safariland finger groove grips for a j-frame smith on my 462. They were able to be made to fit, and now they fit perfectly and look almost factory, but you have to be good with a dremel.

One important caveat: There is a strange 1/4 inch hole below the cylinder release on the 462 that is covered by the factory grips. The speed loader notch on my safariland grips exposes about half of this hole.

I would post pics, but my camera was just stolen

MCgunner
July 28, 2008, 03:32 PM
My Taurus 85 has that same hole. The old Rossis don't. Odd. Pachmayr Grippers have been made for the small frame Rossis for at LEAST 20 years. I have had 'em on my m88 and still have a 511 .22 with a set.

If you enjoyed reading about "Anyone know who sells wood grips for Rossi Revolvers?" here in TheHighRoad.org archive, you'll LOVE our community. Come join TheHighRoad.org today for the full version!